Maytag Dryer F01 Code: Meaning & Fixes
- Meaning
- Primary control failure: the dryer's main electronic control detected an internal fault.
- Can I fix it?
- Sometimes, may need a pro
- Also shown as
- F:01, F-01
- Seen on
- Maytag electric and gas dryers, including commercial-grade residential models. Newer controls show F1 E1; Whirlpool dryers use the same codes.
Maytag’s technical sheets are blunt about F01: the dryer’s main control has detected a failure of its own, and the remedy is new control electronics. Before you order one, try the reset Maytag’s help pages give: breakers off for 5 minutes, then a timed dry cycle while you watch. Newer Maytag controls show the same fault as F1 E1.
Try this first
- Turn off the dryer's circuit breaker(s) for 5 minutes.
- Turn the breaker(s) back on and start a timed dry cycle.
- Watch the dryer for 1 minute. If F01 returns, contact Maytag service.
What causes F01
| Cause | What you notice | What to check |
|---|---|---|
| Temporary control glitch, often after a power surge | F01 once, then normal after the reset | 5-minute breaker reset |
| Failed main control board | F01 returns within a minute of the reset | Needs a technician |
Fix it step by step
Tap a step number to tick it off as you go. Ticks stay on this device.
-
Switch off at the breaker
Turn off the dryer's circuit breaker, or both breakers on an electric dryer, for 5 minutes.
Safety: Electric dryers run on 240 volts. Maytag's technical sheets warn to disconnect power before any service.
-
Restore power
Turn the breaker(s) back on.
-
Run a timed dry cycle
Start a timed dry cycle and watch the dryer for 1 minute to see whether the code comes back.
When to call a technician
If F01 or F1 E1 returns after the reset, contact Maytag service or a technician. Maytag's technical sheet says to replace the machine control electronics, which a technician should match to your model number.
Questions people ask
Is Maytag dryer F01 the same as F1 E1?
Yes. Older Maytag controls show F01, F:01 or F-01; newer ones show F1 E1 for the same main control fault.
Does F01 mean a blocked vent or a bad thermal fuse?
No. Maytag's technical sheets define F01 as a primary control failure. Airflow and heating problems have their own codes.
How long should I turn off the power?
Maytag's help pages say 5 minutes at the circuit breaker, then a timed dry cycle while you watch for 1 minute.