Maytag Washer F1 E1 Code: Meaning & Fixes
- Meaning
- Main control fault: the washer's main control board has detected a fault.
- Can I fix it?
- Sometimes, may need a pro
- Also shown as
- F1E1
- Seen on
- Maytag front-load and top-load washers, and Whirlpool washers with the same controls.
F1 E1 on a Maytag washer points to the main control board. Maytag’s help pages give one owner step: disconnect the washer from power for 5 minutes to reset the control. If the code comes back after that, Maytag says a qualified technician needs to diagnose the washer. Don’t confuse it with the dryer code of the same name.
Try this first
- Unplug the washer for 5 minutes, then plug it back in.
- Reselect the cycle and press Start.
- On top-load models, press Start/Pause once to clear the code and again to restart.
- If F1 E1 returns, contact Maytag service.
What causes F1 E1
| Cause | What you notice | What to check |
|---|---|---|
| Temporary control glitch, often after a power surge | F1 E1 once, then normal after a reset | 5-minute power reset |
| Loose wiring at the main control | F1 E1 comes and goes | Needs a technician |
| Failed main control board | F1 E1 returns after every reset | Needs a technician |
Fix it step by step
Tap a step number to tick it off as you go. Ticks stay on this device.
-
Reset the control
Unplug the washer, or switch off its breaker, for 5 minutes. Then restore power.
-
Restart the cycle
Reselect the cycle and press Start. On top-load models, press Start/Pause once to clear the code and again to restart.
-
Call if it returns
If F1 E1 comes back, stop using the washer and contact Maytag service.
Safety: Don't open the console or panels. The control board is wired to mains power.
When to call a technician
If F1 E1 returns after the 5-minute reset, Maytag says to contact it so a qualified technician can diagnose the washer. The usual repair is a main control board or its wiring.
Questions people ask
Is washer F1 E1 the same as Maytag dryer F1 E1?
Both point to the main control, but on different appliances with different boards. Use the page for your appliance.
How long should I unplug a Maytag washer to reset it?
Maytag's help pages say 5 minutes.
What's the difference between F1 E1 and F1 E2?
Both are control codes. F1 E2 is a separate fault, usually in communication with the motor control, and also needs a technician if it returns.